System podgrzewania Ursus C330. Argiris

System podgrzewania silnika
do ciągnika Ursus C330



Miałeś kiedyś problem z odpaleniem swojej Trzydziestki przy niskich temperaturach?


Znasz sposoby by sprawnie i szybko uruchomić silnik w takich warunkach?


Przedstawiamy jeden z nich,
autorstwa Greka Argirisa!

bo Trzydziestki pracują także w Grecji!

 



System podgrzewania silnika
wg Argirisa
instrukcja wideo

 

 

System podgrzewania silnika
wg Argirisa
krok po kroku



I. Niezbędne elementy

1. Zbiornik płynu hamulcowego płaski

Zbiornik płynu hamulcowego płaski C-360


Sprawdź cenę / zamów / porównaj:   zbiornik płynu hamulcowego


2. Świeca płomieniowa (2 sztuki)


swieca_mf

Sprawdź cenę / zamów / porównaj:  świeca do MF


3. Pompka spryskiwacza

Można znaleźć np. poprzez nokaut: pompka spryskiwacza


4. Przycisk sygnału THE SWITCH OF THE DIESEL PUMP

Przycisk sygnału

Sprawdź cenę / zamów / porównaj: przycisk sygnału 24V

 

5. Przełącznik świec żarowych THE   (two steps)  MAIN SWITCH

Przełącznik świec żarowych

Sprawdź cenę / zamów / porównaj: fabryczny przełącznik do C330

 

 

II. Instalacja

1. Zamocuj zbiornik płynu. Pamiętaj: musi być jak najwyżej.
Poniżej umieść pompkę spryskiwacza.
Pamiętaj: pompka musi być poniżej poziomu zbiornika.

agriris


2. AFTER the pump fit 2 small tubes (with a T  type adapter)to drive the  diesel to the sparks (for the very cold days-we will use  the small pump) or leave the diesel run down to the sparks physically for the not so much cold days –to the sparks.





3. We also  have to do some work to adjust the spark plugs to the holes of  the   PRZEWÓD SSĄCY C-330




4. Połączenia elektryczne
The sparks take electricity from the first step of the main switch of the tractor.
And the pump takes electricity from the momentary switch (a beep type switch)


IV. Uruchomienie

1.    Turn to the first step the main switch of the tractor.
Now the sparks become warm and after a few seconds you hear a baf sound near to the air filter of the tractor. That means that valves of the sparks are open and the diesel which runs physically to them have already in ignition.




2.     Now turn the engine ON (-go to the step two of the main switch.)




3.    With the engine turning for a few seconds-for how long it  deepens from the condition of the diesel pump of the tractor  and the nozzles—( to send diesel to the engine head )



4.    Now is the most important step of the starting sequence PRESS AND HOLD IT DOWN THE SMALL PUMP SWITCH. ( a beep type switch )
The diesel is now pressed to the sparks . The flames  are about  20 cm s  along  and from the opened  Suction valve s   will find the sprayed diesel from the nozzles ……




Brawo! Mamy zapłon!!
Zacytujemy Argirisa: słyszymy piękny dźwięk odpalona traktora



PS.
The time of each step of the starting sequence deepens from the temperature of the day and the condition of the tractor.

This is a preheat system designed from a Greek musician to all friends  in Poland who use URSUS tractors.


 



 

Katalog
Wyszukiwarka filtrów
Pzl Sędziszów
Prześlij CV!